The result is a much more consistent fuel flow/pressure delivered to the injectors, a primed fuel system BEFORE starting the engine, support for moderately upgraded power levels as well as filters that are easier to service and less expensive to replace! Compatible with Both Stock and Aftermarket Turbochargers. Compatible with both "Stealth" and "Terminator" Twin HPOP Setups.
High Quality Fuelab Bypass Fuel Pressure Regulator. Hard Line Used in High Temperature and Tight Radius Locations.Braided Teflon Hoses with BLACK Protective Covering. High Flow Banjo Bolt Kit - RECOMMENDED. Stainless Steel Regulator Mounting Bracket. Marshall Liquid Filled Fuel Pressure Gauge. All Kits Feed Front Ports (away from Turbo Heat) and Return from Rear Ports. Can be Upgraded to "Dual Stock Pump" Setup at a later date (support for more HP). Fuel Pump/Filter Mounting Bracket (No Drilling Req). High Quality Pre & Post Pump Fuel Filter Heads.
Baldwin Pre & Post Pump Fuel Filter Elements. 3/8 Mini Ball Valve Included (shut-off fuel supply during filter change). Complete Pump/Filters Assembly is only 13 Wide!20' of Gates #6 Fuel Line and All Necessary Fittings. Driven Diesel OBS Fuel Pump Wiring Harness w/Pump Controller. All Necessary Hardware for Installation.
This kit RETAINS the fuel tank selector valve... You will still be able to use BOTH fuel tanks using the switch on the dash, like you always have.While we have done everything we can to make this the most compact fuel pump and filter mount on the market at only 13 wide, there are a few applications where the mount will not fit inside the frame. Before ordering, please check your truck for clearance between the front of the fuel tank and the rear of the transfer case (4x4) for the necessary 13"-15" of installation space. If your truck doesn't have enough space inside the frame, this kit CAN be used outside the frame. You will need to disconnect the parking brake cable and route it through our pump mount bracket (we suggest covering it with a piece of split rubber hose as well), and shorten the pump mount bolts that protrude through the rear of the bracket. There should be plenty of extra hose in the kit to cleanly route the fuel lines to this location as well.
Due to the differences we have seen in the condition of body mounts on OBS trucks (distance from frame to body), our pump bracket may contact the underside of the vehicle floor. On the few trucks we have found clearance issues on, the contact was very minor and the easiest solution was to carefully push the floor up about 1/4 in the affected area. We make every attempt possible to source and use as much U. Items marked with a above have been modified or assembled by U. Items marked with above were ENTIRELY produced from U.We can't always control where every component of one of our products comes from, but you count on us to keep looking for ways to increase the % of American Made parts and materials in the products that we produce. Some customers have modified our kit or their van to use this product. While we don't believe that the modifications are significant, we are not aware of the specifics of the modifications and we can NOT provide support for fitting this kit to an E-Series Van. Thank You for your understanding in this matter. We value your business and we are not satisfied until you are. Rudy's Performance Parts ships products from multiple warehouses across the country in order to get your products to you the quickest way possible.
We are not able to send ANY race use products to the state of California. According to the EPA Clean Air Act, they are illegal for use on any Federal, State, or Local public highways and illegal use is punishable by the penalties enacted by the mentioned laws. Rudy's Performance Parts does not condone or promote illegal use of these products. All of our parts and accessories are returnable and refundable.
The item in which you are returning MUST be unused, uninstalled, in the original condition, and in the original packaging. If you are returning an item due to an error caused by Rudys Performance Parts or its business partners i. If you are sending an item back, we recommend using a service with tracking and signature confirmation.
This product is NOT for sale or use in California. The item "Driven Diesel Fuel System Without Fuel Pump For 1994-1997 Ford 7.3L Powerstroke" is in sale since Monday, November 2, 2020. This item is in the category "eBay Motors\Parts & Accessories\Car & Truck Parts\Air Intake & Fuel Delivery\Other". The seller is "rudys_performance_parts" and is located in Chapel Hill, North Carolina.
This item can be shipped to United States, Canada, United Kingdom, Denmark, Romania, Slovakia, Bulgaria, Czech republic, Finland, Hungary, Latvia, Lithuania, Malta, Estonia, Australia, Greece, Portugal, Cyprus, Slovenia, Japan, China, Sweden, South Korea, Taiwan, South africa, Thailand, Belgium, France, Hong Kong, Ireland, Netherlands, Poland, Spain, Italy, Germany, Austria, Bahamas, Israel, Mexico, New Zealand, Singapore, Switzerland, Norway, Saudi arabia, United arab emirates, Qatar, Kuwait, Bahrain, Croatia, Malaysia, Brazil, Chile, Colombia, Panama, Jamaica, Barbados, Bangladesh, Bermuda, Brunei darussalam, Bolivia, Ecuador, Egypt, French guiana, Guernsey, Gibraltar, Guadeloupe, Iceland, Jersey, Jordan, Cambodia, Liechtenstein, Sri lanka, Luxembourg, Monaco, Macao, Martinique, Maldives, Nicaragua, Oman, Peru, Pakistan, Paraguay, Reunion, Viet nam, Uruguay, Ukraine, Cayman islands.